欲望小妹
发表于 2025-3-25 07:10:17
Nanotribology and Nanomechanicsdrates or the tool change positions, to correct errors in the positional data or to alter the values for the tool diameters and lengths. Within the program, you may need to add or delete a block or blocks, or to insert other programs into the main program in the form of sub-programs or macro routines.
JUST
发表于 2025-3-25 10:28:54
Low-Temperature Scanning Probe Microscopy component and therefore to the clamping/holding devices. As the programmer, it is part of your task to decide what type of work-holding device is required for a particular operation. The following conditions must be met:
移动
发表于 2025-3-25 14:12:12
http://reply.papertrans.cn/23/2204/220378/220378_23.png
惩罚
发表于 2025-3-25 17:29:13
https://doi.org/10.1007/978-3-642-15263-4ate on a pull-down menu system which requires the name of the previously defined pocket shape and the name of each ‘island’ within the pocket. Or a pocket clearance routine within the software may be used to define the shape of the pocket, including ‘islands’. In either case, the data entered is used to generate the cutter toolpaths.
慷慨援助
发表于 2025-3-25 20:23:46
http://reply.papertrans.cn/23/2204/220378/220378_25.png
反应
发表于 2025-3-26 00:17:03
Nanotribology and Nanomechanics II-ordinates are tabulated at the top left-hand corner of the drawing, thus avoiding a mass of dimension lines. A spline (a series of points through which a smooth curve is drawn) is shown along the top edge of the component. Consult your manual and research the commands that your CAD/CAM system uses for drawing splines.
HARP
发表于 2025-3-26 07:27:20
Input and edit function,drates or the tool change positions, to correct errors in the positional data or to alter the values for the tool diameters and lengths. Within the program, you may need to add or delete a block or blocks, or to insert other programs into the main program in the form of sub-programs or macro routines.
Excise
发表于 2025-3-26 10:51:07
http://reply.papertrans.cn/23/2204/220378/220378_28.png
发出眩目光芒
发表于 2025-3-26 15:31:00
http://reply.papertrans.cn/23/2204/220378/220378_29.png
珠宝
发表于 2025-3-26 17:34:57
Machining pockets,ate on a pull-down menu system which requires the name of the previously defined pocket shape and the name of each ‘island’ within the pocket. Or a pocket clearance routine within the software may be used to define the shape of the pocket, including ‘islands’. In either case, the data entered is used to generate the cutter toolpaths.