Introduction
发表于 2025-3-23 12:53:19
Nanotribology and Nanomechanicsdrates or the tool change positions, to correct errors in the positional data or to alter the values for the tool diameters and lengths. Within the program, you may need to add or delete a block or blocks, or to insert other programs into the main program in the form of sub-programs or macro routine
Halfhearted
发表于 2025-3-23 16:57:09
http://reply.papertrans.cn/23/2204/220378/220378_12.png
innate
发表于 2025-3-23 18:42:23
Mechanical Properties of Nanostructuresder to machine the required shape. These calculations may be needed to determine the intersect points of arcs and lines, arc centres and tangency points of lines on arcs or circles, and so on. If you are going to write programs manually, you will need a good knowledge of mathematics, trigonometry an
奇思怪想
发表于 2025-3-24 01:04:58
Nanotribology and Nanomechanics Itines. These are built into the controller’s computer software and make it easy to program routine machining sequences. Such routines are drilling, tapping, spot-facing and area clearance for square pockets, circular pockets and boring cycles. The difference between the two is that a canned cycle is
OFF
发表于 2025-3-24 04:09:29
Mechanical Properties of Nanostructurespy. They may, however, use different ways to input information and data, such as moving a tracker ball or a mouse, or simply typing commands using the keyboard. Various facilities may also be available for transferring CNC programs to machine tools, such as a punched tape/reader or a magnetic tape c
Adrenal-Glands
发表于 2025-3-24 08:40:00
Mechanical Properties of Nanostructures, tangents between circles, arcs through a point tangential to a line and so on. The main difference is in the way that you construct the geometry, since you only need to draw details like the profile shape or the hole positions. You do not have to incorporate features like hatching lines, dimension
misanthrope
发表于 2025-3-24 14:10:24
http://reply.papertrans.cn/23/2204/220378/220378_17.png
nonsensical
发表于 2025-3-24 17:05:01
http://reply.papertrans.cn/23/2204/220378/220378_18.png
CAGE
发表于 2025-3-24 19:17:58
http://reply.papertrans.cn/23/2204/220378/220378_19.png
genesis
发表于 2025-3-25 00:48:05
Nanotribology and Nanomechanics II-ordinates are tabulated at the top left-hand corner of the drawing, thus avoiding a mass of dimension lines. A spline (a series of points through which a smooth curve is drawn) is shown along the top edge of the component. Consult your manual and research the commands that your CAD/CAM system uses