漂浮
发表于 2025-3-25 07:21:32
Conference proceedings 2025s, are also discussed. Overall, this book provides academics and practitioners with extensive information on state-of-the-art theories and methods that can be used to understand, analyse and improve the rapidly growing field high-velocity water jet technology..
LIKEN
发表于 2025-3-25 10:17:09
https://doi.org/10.1007/978-3-662-65240-4eter is considered for the experimental part and the numerical computation. The results obtained from the experiments and the numerical simulation of the abrasive water jet show very good agreement. The details of the performed studies are presented in this paper.
Harpoon
发表于 2025-3-25 15:06:29
http://reply.papertrans.cn/17/1674/167325/167325_23.png
完成
发表于 2025-3-25 17:46:33
Guanidines as Reagents and Catalysts IItter of values. Signal (S) is gained from factors are set or under the control of the user, but the noise (N) shows the factors affecting the signal beyond user control. In the case of cutting the KS Permaglide P10 material, the validity of using the AWJ technology was confirmed, and the optimal machining parameters were determined.
能得到
发表于 2025-3-25 21:38:33
http://reply.papertrans.cn/17/1674/167325/167325_25.png
interior
发表于 2025-3-26 04:09:01
https://doi.org/10.1007/978-3-319-22653-8. Here, a dense-sintered technical ceramic made of zirconia was used. Moreover, the study suggests that the absence of air suppresses high-frequency droplet erosion, minimising material outbreaks of brittle-hard materials.
过多
发表于 2025-3-26 06:44:16
http://reply.papertrans.cn/17/1674/167325/167325_27.png
considerable
发表于 2025-3-26 11:47:34
http://reply.papertrans.cn/17/1674/167325/167325_28.png
讨好女人
发表于 2025-3-26 13:24:32
Influence of Abrasive Water Jet Cutting Parameters on the Surface Properties of Modern Plain Bearintter of values. Signal (S) is gained from factors are set or under the control of the user, but the noise (N) shows the factors affecting the signal beyond user control. In the case of cutting the KS Permaglide P10 material, the validity of using the AWJ technology was confirmed, and the optimal machining parameters were determined.
大喘气
发表于 2025-3-26 19:57:22
Preliminary Investigation of the Cutting Edge Preparation of Carbide Tools Using the Abrasive Waters up to 300 MPa was conducted. The aim of this analysis was to conduct a preliminary investigation of the application of this technology as a cutting edge preparation process, as well as describing the influence of process parameters on the prepared cutting edge radius.