产生
发表于 2025-3-30 11:43:21
http://reply.papertrans.cn/15/1488/148781/148781_51.png
含糊
发表于 2025-3-30 14:19:01
http://reply.papertrans.cn/15/1488/148781/148781_52.png
Influx
发表于 2025-3-30 19:37:18
Modern Acoustics and Signal Processinga single point tool therefore it is called the single-point incremental forming (SPIF). The surface finish is the common issue in SPIF which is increased with the processing of hard materials. In the present study, the brass Cu67Zn33 is formed through SPIF, and nano-scale surface roughness is measur
裂缝
发表于 2025-3-30 23:52:29
Modern Acoustics and Signal Processingile, shipbuilding, aerospace, electronics, medical industries, etc. Surface finish of these types of components is one of the most important criteria for fabricating better quality and to avoid failure caused by surface defects. The paper addresses the experimental investigation for the variation of
多嘴
发表于 2025-3-31 04:44:20
http://reply.papertrans.cn/15/1488/148781/148781_55.png
带来的感觉
发表于 2025-3-31 08:53:00
Rehabilitation and Habilitation, inlet air passed to the cylinder by using specifically designed and manufactured heat exchanger. A diesel generating set having a cylinder, 5 horse power (HP), water cooled, Kirloskar Make diesel engine was selected as base engine and the experiments were conducted at part load conditions. The dies
Insatiable
发表于 2025-3-31 10:54:04
Modern Acoustics and Signal Processingghness, burr size and microhardness. For this case study, micro-milling operation has been carried out for the combination of TiAlN-coated 0.5-mm flat end mill and P-20 steel in dry environment. To avoid the ploughing effect, experiments have been performed in shearing dominated region for three fee
BOOST
发表于 2025-3-31 13:20:48
http://reply.papertrans.cn/15/1488/148781/148781_58.png
变态
发表于 2025-3-31 17:42:23
Modern Acoustics and Signal Processingsidering this fact as a primary objective, the present study is carried out to determine the average surface roughness (Ra), root mean square (Rq), and average maximum height of the profile (Rz) values of surfaces generated during the machining of MS rod. Plain turning operation is carried out in a