合适
发表于 2025-3-25 03:57:32
https://doi.org/10.1007/978-3-319-97788-1his study, the nickel powder was melted and deposited on the stainless steel SS202 substrate. The process parameters used are laser power, travel speed and powder feed rate. The microhardness of the clad layer was measured, and the macrostructure of the clad area was analysed. The influences of the
VICT
发表于 2025-3-25 08:25:40
http://reply.papertrans.cn/15/1488/148743/148743_22.png
水槽
发表于 2025-3-25 11:48:35
http://reply.papertrans.cn/15/1488/148743/148743_23.png
有发明天才
发表于 2025-3-25 16:54:44
978-981-13-4669-9Springer Nature Singapore Pte Ltd. 2019
Glycogen
发表于 2025-3-25 22:48:09
Springer Optimization and Its Applicationsie semi-cone angle (20°). The forming characteristics such as thickness distribution (along . and .) and bulged diameter were studied using toolmakers microscope and coordinate measuring machine. Maximum shear thinning is observed in the largest diameter of the bulged portion of the tube.
cringe
发表于 2025-3-26 02:47:59
http://reply.papertrans.cn/15/1488/148743/148743_26.png
聋子
发表于 2025-3-26 05:19:51
http://reply.papertrans.cn/15/1488/148743/148743_27.png
GRAZE
发表于 2025-3-26 10:09:21
http://reply.papertrans.cn/15/1488/148743/148743_28.png
威胁你
发表于 2025-3-26 12:39:06
https://doi.org/10.1057/9780230599673parameters in EDM, which influence several performance characteristics such as overcut, circularity, electrode wear rate, material removal rate, and taper angle. The intended technique can be used to select best and worst machining parameter among the various sets of combinations of machining parameter in EDM for small-hole drilling.
Thyroid-Gland
发表于 2025-3-26 19:05:16
Robert Mies,Jérémy Bonvoisin,Roland Jochems at two stages: (a) fresh tool and (b) after CD. Concave circular tool possessed a minimum percentage of weight loss, i.e., 4.92% after CD and is revealed as a most effective tool, which could be used for drilling purpose followed by the hollow abrasive tool.