carotenoids
发表于 2025-3-25 05:28:48
Robust Model Calibration with Load Uncertainties,bjected to uncertain loads. Lack of knowledge is commonplace in this kind of engineering system and a realistic model calibration cannot be performed without taking into account this type of uncertainty. The question at stake in this study is how to perform a robust predictive model of a dynamic sys
cliche
发表于 2025-3-25 07:38:24
http://reply.papertrans.cn/93/9263/926233/926233_22.png
Fraudulent
发表于 2025-3-25 11:46:24
http://reply.papertrans.cn/93/9263/926233/926233_23.png
URN
发表于 2025-3-25 18:16:25
Orthogonality for Modal Vector Correlation: The Effects of Removing Degrees-of-Freedom,uce Finite Element Model (FEM) based mass matrices and the Modal Assurance Criterion (MAC). These associated technologies have all been developed to try and correlate the FEM and experimentally obtained mode shapes. A case study is presented where the Effective Independence method for Degree-of-Free
Curmudgeon
发表于 2025-3-25 23:07:22
CAE Model Correlation Metrics for Automotive Noise and Vibration Analysis,horten development time. To serve their purpose, it is important to understand the CAE capability of a model. A metric is essential to quantify this capability as well as track its history for improvement over the time. In particular, the noise and vibration sensitivity of a vehicle to a unit force
TAIN
发表于 2025-3-26 03:17:07
Damage Localization Using a Statistical Test on Residuals from the SDDLV Approach,ems, when the excitation is not measurable, can be carried out using the Stochastic Dynamic Damage Locating Vector (SDDLV) approach, a method that interrogates changes in a matrix that has the same kernel as the change in the transfer matrix at the sensor locations. Damage location is related to som
anthropologist
发表于 2025-3-26 08:12:13
Robust Tolerance Design in Structural Dynamics,ed products. A systematic tolerance design strategy is required to control this kind of variation, and an approach for tolerance design based on robust design theory is proposed in this paper with a focus on the optimization of the dynamic response. The approach is based on Taguchi’s method, and per
Brochure
发表于 2025-3-26 11:45:12
http://reply.papertrans.cn/93/9263/926233/926233_28.png
直言不讳
发表于 2025-3-26 14:09:34
Crossing and Veering Phenomena in Crank Mechanism Dynamics,nal design process. From experimental point of view, a change in a system parameter due to the need of describing a different assembly configuration, can require iterative measurements, and can be quite time consuming. On the other hand, by evaluating the dynamic behaviour of the single component in
vasculitis
发表于 2025-3-26 19:01:00
http://reply.papertrans.cn/93/9263/926233/926233_30.png