disciplined
发表于 2025-3-23 12:50:21
Influence of Stacking Sequence on Mechanical Properties and Vibration Characteristics of Glass/Carbo characteristics were investigated. For understanding and analysing the influence of stacking sequence, the laminates were made with different fabric areal densities. Four layered Glass/Carbon hybrid laminates with two different fundamental stacking sequences were fabricated. In the first-type lamin
突变
发表于 2025-3-23 17:15:16
http://reply.papertrans.cn/88/8800/879970/879970_12.png
bromide
发表于 2025-3-23 18:49:31
http://reply.papertrans.cn/88/8800/879970/879970_13.png
得体
发表于 2025-3-23 23:54:55
Improvement on High-Temperature Mechanical Properties of Modified 9Cr-1Mo Steel Through Intermediate present investigation, intermediate hot rolling on modified 9Cr-1Mo steel have been performed in austenitic phase (1050 °C) and below austenitic phase (550 °C). Intermediate hot rolling including normalization at elevated temperature (1150 °C), followed by tempering (700 °C) is employed to refine i
chisel
发表于 2025-3-24 02:53:11
http://reply.papertrans.cn/88/8800/879970/879970_15.png
关节炎
发表于 2025-3-24 10:28:34
http://reply.papertrans.cn/88/8800/879970/879970_16.png
Innocence
发表于 2025-3-24 12:25:15
Evolution of Tribological Properties of Cast Al–10Zn–2Mg Alloy Subjected to Severe Plastic Deformati. In this work, one of the SPD techniques, equal channel angular pressing (ECAP) was adopted as a processing tool. ECAP was carried out in route B. and processing was attempted at the lowest temperature. After ECAP, grain structure of the material was refined and considerable improvement in the micr
横条
发表于 2025-3-24 15:10:28
http://reply.papertrans.cn/88/8800/879970/879970_18.png
travail
发表于 2025-3-24 20:39:52
Deformation and Fracture Behavior of Cold-Drawn Pearlitic Steel Wires After Heat Treatmentey also exhibit a loss in ductility due to the high dislocation density and residual stresses that they accumulate during wire drawing. Hence, they are subjected to stress-relieving annealing treatments during which they undergo further microstructural changes. The aim of this work is to investigate
Ornament
发表于 2025-3-25 02:51:06
http://reply.papertrans.cn/88/8800/879970/879970_20.png