Hiatus
发表于 2025-3-28 16:41:53
Jeffrey S. Banks,John Dugganther MMCs specimen except of Mg/2.5 wt% ZnO and MMCs reinforced containing ZnO particles exhibit higher cutting force than that containing BN particles. Moreover, compared to the pure Mg, chips with different morphology can be found in machining MMCs.
Uncultured
发表于 2025-3-28 21:11:35
Norman Schofieldredicts that certain alloying elements, particularly rare-earth elements (e.g., Y, Ce, Nd, Gd, etc.), could alter the active deformation modes, and promote more homogeneous deformation and overall mechanical properties in Mg. Therefore, this work aims to investigate experimentally the effects of all
即席
发表于 2025-3-29 01:22:30
http://reply.papertrans.cn/87/8694/869332/869332_43.png
阻碍
发表于 2025-3-29 05:02:52
Jean-François Lasliere pyramidal II plane, a single solute may induce migration of the SF. Constraints, and corrections for the constraints, are thus needed. In the random alloy, every atom site has a probability . (in at.) to be occupied by a solute atom. The value of the SF energy of the alloy, at small ., is then ..T
直言不讳
发表于 2025-3-29 09:32:25
Rangarajan K. Sundarament Mg–Al–Ce phase diagram. In addition, a hexagonal Al.Ce. phase which is isostructural with Al.La. has been identified in these alloys. The research addresses some of the current limitations in understanding the effect of Ce, when added in isolation, on microstructure development in Mg–Al based al
嘴唇可修剪
发表于 2025-3-29 12:10:07
Bhaskar Dutta,Matthew O. Jackson,Michel Le Bretonthat although, ZE41 and EZ33 have the same primary alloying elements, due to the addition of REs, differences in composition, nature of precipitates and passivating layer play a key role in positively impacting the corrosion behavior and hence, the corrosion rate.
graphy
发表于 2025-3-29 18:02:27
http://reply.papertrans.cn/87/8694/869332/869332_47.png
搬运工
发表于 2025-3-29 23:08:24
Randall L. Calvert,Nathan Dietz The results revealed mean coefficient of friction of 0.857 and 0.478 for 1 N and 10 N loads, respectively. Friction stir processing proves to be an adequate technique of improving the surface properties of magnesium alloy when using PKs ash powder as reinforcement.