irreducible 发表于 2025-3-23 12:08:19

http://reply.papertrans.cn/84/8312/831170/831170_11.png

tic-douloureux 发表于 2025-3-23 15:42:06

Design of a Scalable Wall Climbing Robot for Inter-plane Traversingts of two modules connected by an active joint. The joint is equipped with a motor, which can drive the joint to the desired direction. The robot also adopts a balance tail to avoid rolling over. These mechanisms enable the robot to make transition between walls. The mechanical analysis and kinemati

Affluence 发表于 2025-3-23 20:54:08

Handheld Device System Development for Video Camera Movement Control System handwheel for the motion control system. The handwheel development should match to the control system. This paper explores the handwheel control memory configuration of the UMAC motion control cards and achieves the rocker and buttons two basic functions. Manufacture the SCM system with analog sign

Assemble 发表于 2025-3-24 00:05:41

http://reply.papertrans.cn/84/8312/831170/831170_14.png

acquisition 发表于 2025-3-24 03:06:31

A Self-calibration Algorithm with Chaos Particle Swarm Optimization for Autonomous Visual Guidance oimization (PSO) algorithm in camera calibration. Then proposes a new algorithm CPSO, combining PSO with chaos optimization algorithm, to optimize camera’s intrinsic parameters based on absolute conics. Finally we carry out experiments to test its performance. Re-projection errors show that the metho

死猫他烧焦 发表于 2025-3-24 10:02:23

Simultaneous Calibration of a Stereo Vision System and a Welding Robot-an Automated Approachckly and accurately calibrated. The work presented in this paper aims to develop a new method for calibrating a vision guided arc welding robot. This is achieved through automated calibration of the cameras and the optimised simultaneous calibration of a robot arm and robot mounted stereo vision sys

痴呆 发表于 2025-3-24 10:54:00

Conference proceedings 2015ogical parts: Intelligent Techniques for Robotic Welding, Sensing of Arc Welding Processing, Modeling and Intelligent Control of Welding Processing, as well as Intelligent Control and its Applications in Engineering.. .

Nucleate 发表于 2025-3-24 16:52:11

Tracking on Right-Angle Weld with Drain Holes by Robot drain hole has been detected. Ignite the arc after passing through drain holes with path planning. The accurate identification of intersection is very important when the robot is in the quarter turn stage. Finally, the correctness of the algorithm is proved by the experiments of tracking on right-angle weld.

才能 发表于 2025-3-24 20:32:18

Influence of Heat Input on the Performance of Joint with Filling Wire Laser Welding 5A06 Aluminum Alre improvement and the damage position was migrating from HAZ to base metal. Scanning electron microscope (SEM) observation on the fracture surface of welded joint showed that the pores exerted a great influence on the reduction in strength and elongation, but the microstructure of the welding seam hardly affected the tensile properties.

Asperity 发表于 2025-3-25 02:32:05

http://reply.papertrans.cn/84/8312/831170/831170_20.png
页: 1 [2] 3 4 5 6 7
查看完整版本: Titlebook: Robotic Welding, Intelligence and Automation; RWIA’2014 Tzyh-Jong Tarn,Shan-Ben Chen,Xiao-Qi Chen Conference proceedings 2015 Springer Inte