惊呼
发表于 2025-3-25 04:25:31
http://reply.papertrans.cn/83/8282/828197/828197_21.png
ungainly
发表于 2025-3-25 11:28:43
http://reply.papertrans.cn/83/8282/828197/828197_22.png
dialect
发表于 2025-3-25 13:38:19
http://reply.papertrans.cn/83/8282/828197/828197_23.png
DALLY
发表于 2025-3-25 15:51:14
Residual Stresses and Fracture Mechanics,ly in the literature. Generally, compressive residual stresses are found to be beneficial in fracture calculations while tensile residual stresses degrade the strength of a part. However, in the first part of this chapter we will point out that the local compressive residual stresses, and sub-surfac
取消
发表于 2025-3-25 23:45:02
http://reply.papertrans.cn/83/8282/828197/828197_25.png
NEG
发表于 2025-3-26 00:52:51
0941-5122 re mechanics to residual stress measurements.and the relatio.Residual Stress Measurement and the Slitting Method provides complete coverage of the slitting method with new results in analysis, computation and estimation. It discusses different roles of residual stresses from the fracture mechanics p
幻影
发表于 2025-3-26 07:47:12
Residual Stresses and Fracture Mechanics, crack will experience tensile loading. What is often ignored is that the compressive stresses close the crack at the surface and make it more difficult to detect by dye penetrant techniques . An attempt is made here to quantify these observations using procedures based on linear elastic fracture mechanics (LEFM).
公理
发表于 2025-3-26 10:28:11
Introduction to Residual Stresses,rd was often the result of a thin layer of compressive residual stress induced by repeated hammering at a controlled elevated temperature. Even today, the presence of residual stresses still dictates the design of many components, whether in a spacecraft or a tiny integrated circuit.
Paradox
发表于 2025-3-26 16:22:14
http://reply.papertrans.cn/83/8282/828197/828197_29.png
表被动
发表于 2025-3-26 19:28:08
Compliance Functions for Through-Thickness Measurement: The FEM Approach,ons for a specimen of a complex geometry. Since this approach allows the compliance functions to be obtained for a crack as well as a slit of finite width,in what follows,we will use the term “compliance functions” interchangeably for a crack and a slot.