BRUNT
发表于 2025-3-25 04:45:42
http://reply.papertrans.cn/63/6258/625788/625788_21.png
希望
发表于 2025-3-25 07:38:37
http://reply.papertrans.cn/63/6258/625788/625788_22.png
昏迷状态
发表于 2025-3-25 15:04:15
Modeling of Transient Fluid Flow, Solidification Processes and Bubble Transport in Continuous Castin in a slab continuous casting mold. Transient flow of molten steel in the continuous casting mold is computed using large eddy simulation. A general enthalpy method is presented for the analysis of solidification processes. The transport of bubbles in the liquid pool of the solidified shell is consi
慷慨援助
发表于 2025-3-25 16:11:39
http://reply.papertrans.cn/63/6258/625788/625788_24.png
Affiliation
发表于 2025-3-25 20:32:32
Measurement and Observation of the Filling Process of Steel Castingst system for the filling process of casting based on contact time method and an observation system for the filling process of casting based on high speed camcorders working under high temperature. By using these two systems, the filling process of a turbine blade and a hub casting were measured and
Yag-Capsulotomy
发表于 2025-3-26 00:56:38
Influence of Load Paths and Bake Hardening Conditions on the Mechanical Properties of Dual Phase Steial being of importance for shaping of body structures. Normally the BH effect is assessed using the uniaxial tension test. In reality shaped parts show a variety of stress paths, starting from deep drawing over uniaxial, plane strain to biaxial conditions. This is the special aspect of the analysis
Spina-Bifida
发表于 2025-3-26 05:22:25
http://reply.papertrans.cn/63/6258/625788/625788_27.png
增强
发表于 2025-3-26 09:08:09
http://reply.papertrans.cn/63/6258/625788/625788_28.png
弯曲的人
发表于 2025-3-26 12:51:51
http://reply.papertrans.cn/63/6258/625788/625788_29.png
昏迷状态
发表于 2025-3-26 16:51:06
Effect of Microstructure Evolution on Hot Cracks of HSLA Steel during Hot Charge Process specimens charged at 750°C and 700°C respectively was lath martensite, banite, polygonal ferrite and the film-like ferrite along the prior austenite grain boundaries. As the specimen was charged at 700°C and reheated to 800°C∼1150°C, it can be obviously observed that cracks both distributed on the