评论性
发表于 2025-3-27 00:54:30
Silicon Nanomachining by Scanning Probe Lithography and Anisotropic Wet Etching,uctor materials using a Scanning Probe Microscope (SPM). The advantages of the SPM lithography technique are its high resolution and absence of radiation damage in the substrate to be patterned. Scanning Probe Lithography (SPL) is highly dependent on tip bias, tip force, scanning speed and air humid
Gingivitis
发表于 2025-3-27 05:05:11
A Novel Bulk Micromachining Method in Gallium Arsenide,ased micro-structures using (001) GaAs substrate. For obtaining wet-etching properties with respect to crystallographic orientation, the etch rates and undercut rates of (001) GaAs are measured using various compositions of NH.OH-H.O.-H.O mixed solutions. From these experimental data, a new GaAs mic
分开如此和谐
发表于 2025-3-27 07:30:19
http://reply.papertrans.cn/63/6258/625752/625752_33.png
奴才
发表于 2025-3-27 12:53:42
Spray Coating Technology of Photoresist/Polymer for 3-D Patterning and Interconnect,ection by spray technology has been studied. Specifically, the study was on the OmniSpray coating technology developed by Electronics Vision Group Austria . Results of the present investigation confirm the superiority of the technique in comparison with the more conventional spin coating method
facilitate
发表于 2025-3-27 15:13:32
http://reply.papertrans.cn/63/6258/625752/625752_35.png
刚开始
发表于 2025-3-27 20:11:50
http://reply.papertrans.cn/63/6258/625752/625752_36.png
A保存的
发表于 2025-3-28 00:57:00
http://reply.papertrans.cn/63/6258/625752/625752_37.png
Connotation
发表于 2025-3-28 06:03:45
Magnetron Sputtered TiNiCu Shape Memory Alloy Thin Film for MEMS Applications,pon heating and cooling. Freestanding TiNiCu thin film showed clearly pronounced “two-way” shape memory effect, which is quite applicable to develop thin film micro-actuators. By depositing TiNi films on the bulk micromachined Si cantilever structures, micro-beams exhibiting good shape-memory effect
名字
发表于 2025-3-28 07:06:02
Chemically Amplified Resist for Micromachining Using X-Ray Lithography,nce of UVIII could be optimised at the post-bake temperature of 140.C and time of 2 minutes, and x-ray exposure dose of 18 mJ/cm.. The results were confirmed by Scanning Electron Microscopic (SEM) studies on UVIII test structures, which were processed using the optimised condition. Test structure as
PHIL
发表于 2025-3-28 11:42:59
Silicon Nanomachining by Scanning Probe Lithography and Anisotropic Wet Etching,n SPM tip is around 10 nm. Samples were hydrogen-passivated by dipping in 10% aqueous HF solution for 15 sec to remove surface native oxide before performing SPM local oxidation process. Then, anisotropic wet etching process was followed with a 34 wt.% aqueous KOH solution at 40°C for 45 sec. Utiliz