假装是你
发表于 2025-3-23 10:34:11
Workpiece Materials,cture toughness are required to give low cutting forces, low cutting temperatures and hence low tool wear rates at high rates of production. This chapter explains the main microstructural and material properties of a wide range of metals and alloys and the effect of these properties on machining beh
发出眩目光芒
发表于 2025-3-23 14:55:26
http://reply.papertrans.cn/63/6204/620340/620340_12.png
混沌
发表于 2025-3-23 18:22:16
Book 1983essity, does not attempt to give detailed information about the machining characteristics of a wide range of tool and workpiece materials. It is felt that this is beyond the scope of the book and is best left to other sources, such as machinability data banks and the Machining Handbook*, whose main
Nonconformist
发表于 2025-3-23 23:50:04
http://reply.papertrans.cn/63/6204/620340/620340_14.png
老巫婆
发表于 2025-3-24 04:05:27
B. Mills B.Sc., M.Sc., Ph.D., C.Eng., F.I.M., M.Inst.P.,A. H. Redford B.Sc., Ph.D., A.R.T.C.S.
叫喊
发表于 2025-3-24 08:16:16
B. Mills B.Sc., M.Sc., Ph.D., C.Eng., F.I.M., M.Inst.P.,A. H. Redford B.Sc., Ph.D., A.R.T.C.S.
动机
发表于 2025-3-24 14:26:19
http://reply.papertrans.cn/63/6204/620340/620340_17.png
cluster
发表于 2025-3-24 15:22:08
B. Mills B.Sc., M.Sc., Ph.D., C.Eng., F.I.M., M.Inst.P.,A. H. Redford B.Sc., Ph.D., A.R.T.C.S.
APNEA
发表于 2025-3-24 21:05:51
B. Mills B.Sc., M.Sc., Ph.D., C.Eng., F.I.M., M.Inst.P.,A. H. Redford B.Sc., Ph.D., A.R.T.C.S.
幻想
发表于 2025-3-25 00:35:08
http://reply.papertrans.cn/63/6204/620340/620340_20.png