浮雕
发表于 2025-3-25 06:56:57
Measure Phase and Statistical Chartingase in six sigma for improvement projects quantitatively evaluates the current or default system KIVs, using thorough measurements of key output variables (KOVs) before changes are made. This information aids in evaluating effects of project-related changes and assuring that the project team is not
滴注
发表于 2025-3-25 08:50:28
http://reply.papertrans.cn/48/4737/473676/473676_22.png
使尴尬
发表于 2025-3-25 12:51:22
Control or Verify Phasemmendations are confirmed and institutionalized. This follows because inspection controls are being put in place to confirm that the changes do initially increase quality and that they continue to do so. If the associated project involves new product or service design, this phase also involves confi
diskitis
发表于 2025-3-25 16:34:15
Advanced SQC Methods other similar methods developed by researchers. Many of these methods are published in such respected journals as the ., ., and .. In general, the other methods offer additional features and advantages.
羽饰
发表于 2025-3-25 23:35:30
http://reply.papertrans.cn/48/4737/473676/473676_25.png
UTTER
发表于 2025-3-26 01:54:59
SQC Theorye, practitioners of six sigma have demonstrated that it is possible to derive value from statistical methods while having little or no knowledge of statistical theory. However, understanding the implications of probability theory (assumptions to predictions) and inference theory (data to informed as
TERRA
发表于 2025-3-26 07:43:03
DOE: The Jewel of Quality Engineeringnt part of a thorough system optimization, yielding definitive system design or redesign recommendations. These methods all involve the activities of experimental planning, conducting experiments, and fitting models to the outputs. An essential ingredient in applying DOE methods is the use of proced
Hyperalgesia
发表于 2025-3-26 10:10:34
DOE: Screening Using Fractional Factorialsnputs cause average outputs to change. “. .” is the process of starting with a long list of possibly influential factors and ending with a usually smaller list of factors believed to affect the average response. More specifically, the methods described in this section permit the simultaneous screeni
薄膜
发表于 2025-3-26 14:51:50
DOE: Response Surface Methodstem input-output relationships and (2) to “tune” or optimize thoroughly of the system being designed. Since these methods require more runs for a given number of factors than screening using fractional factorials, they are generally reserved for cases in which the importance of all factors is assume
Dedication
发表于 2025-3-26 18:37:17
DOE: Robust Designcally only a small fraction of units fail to conform to specifications. If characteristic values were consistent, then either 100% of units would conform or 0%. Robust design methods seek to reduce the effects of input variation on a system’s outputs to improve quality.