Halfhearted
发表于 2025-3-26 23:42:29
http://reply.papertrans.cn/48/4737/473672/473672_31.png
沙文主义
发表于 2025-3-27 02:54:14
The Crystalline Statew discontinuities (Figure 4.1(b), (c)). As the temperature falls there is a steady decrease in the kinetic energy of the atoms or molecules that make up the liquid, and hence a steady.increase in the viscosity of the fluid. Materials that show cooling curves of the type shown in Figure 4.1(a) change
运气
发表于 2025-3-27 06:12:59
Constitutiontter that is homogeneous. Mechanical sub-division of a phase will produce small portions indistinguishable from one another. A polycrystalline pure metal is, therefore, a single-phase material as all the individual crystal grains are alike in composition, crystal structure and state. A material does
怕失去钱
发表于 2025-3-27 13:25:41
Electrical and Magnetic Propertiesed by movement of electrons, or by the migration of ions. Conduction in metals is due to electron migration, but it is the movement of ions that is responsible for the conductivity of electrolytes and for the very low conductivities observed in some insulating materials. In the class of materials kn
creatine-kinase
发表于 2025-3-27 15:39:50
The Shaping of Materialsh in size and complexity, ranging from micro-electronic components to large castings and forgings of, perhaps, several hundred tonnes mass (1 tonne = 1000 kg = 1 Mg). The engineer must have some awareness of the range of manufacturing processes available, and of the advantages and limitations of the
直觉好
发表于 2025-3-27 17:54:39
http://reply.papertrans.cn/48/4737/473672/473672_36.png
Aprope
发表于 2025-3-28 01:38:50
http://reply.papertrans.cn/48/4737/473672/473672_37.png
热情的我
发表于 2025-3-28 05:45:02
Thermoplasticsunted to about 30 per cent of the total volume of world metals consumption, and was about six times greater than the total volume production of all non-ferrous metals. One forecast figure is that the total world volume consumption of plastics will equal the volume consumption of metals by the mid-19
Acquired
发表于 2025-3-28 09:40:20
Thermosetting Materialsfrom a plastic mass into a hard and rigid material. During the heating, or ., process further polymerisation occurs and a full network molecular structure is formed. There are also a number of materials that will set hard and rigid at ordinary temperatures. These . materials are of the same general
合唱团
发表于 2025-3-28 10:58:30
http://reply.papertrans.cn/48/4737/473672/473672_40.png