Exposition
发表于 2025-3-26 23:12:21
Formation of a Soil Wedge by a Bulldozer with a Controlled Bladeoil or rocks was implemented. The volume of the soil wedge moving through the trench increases by 15–20% compared with the layer by layer excavation. The use of a hydraulic drive allows improving the capabilities of working equipment. The operating process of the soil wedge formation and transportat
Indelible
发表于 2025-3-27 02:46:22
On the Impact of Metrological Support on Efficiency of Special Equipmentbasic complexity is connected by difficulties formalization of such system. The system is difficult to formalize primarily because of the large number of goals and sub-goals of metrological support. Moreover, the goals and sub-goals are often contradictory. This leads to the need for search of compr
SLUMP
发表于 2025-3-27 06:42:37
http://reply.papertrans.cn/48/4720/471987/471987_33.png
CAB
发表于 2025-3-27 09:35:36
http://reply.papertrans.cn/48/4720/471987/471987_34.png
珊瑚
发表于 2025-3-27 17:24:10
Selecting a Turnout Curve Form in Railroad Switches for High Speeds of Movementside track by limiting the values of the so-called centrifugal acceleration and increment (change) of centrifugal acceleration per unit time (second). If it is necessary to realize the movement speed of the railroad switch on the side track over 50 km/h, the main factor in determining the radius of
Sedative
发表于 2025-3-27 20:27:33
http://reply.papertrans.cn/48/4720/471987/471987_36.png
monopoly
发表于 2025-3-28 00:38:29
Deformations and Life Periods of the Switch Chairs of the Rail Switchesof cracks due to the high level of bending stresses. The switch chair is a plate of variable stiffness lying on an elastic foundation. The paper considers the built probabilistic model of the operation of switch chairs of the rail switches on reinforced concrete bars, well consistent with the result
注意
发表于 2025-3-28 03:38:18
Wear Peculiarities of Point Frogst part relative to the counter-rails due to the selection of joint backlash. Next is crushing of the metal without (second stage) and with a change in the position of the regulated wear points (third stage) and galling without crushing (fourth steady-state wear stage). It was established that the we
BYRE
发表于 2025-3-28 09:52:14
http://reply.papertrans.cn/48/4720/471987/471987_39.png
Notorious
发表于 2025-3-28 13:29:07
International Scientific Conference Energy Management of Municipal Facilities and Sustainable Energy978-3-030-57450-5Series ISSN 2194-5357 Series E-ISSN 2194-5365