exceed
发表于 2025-3-25 04:09:54
Improving the Productivity of Information Technology for Processing Indirect Measurement Data,ignal of the crankshaft speed of an internal combustion engine based on the use of the capabilities of modern software environments. For the first time, a mechanical system with five degrees of freedom is proposed as a deterministic mathematical model of the torque scheme of a power unit. The Laplac
使苦恼
发表于 2025-3-25 11:01:10
http://reply.papertrans.cn/48/4715/471417/471417_22.png
Grandstand
发表于 2025-3-25 13:03:26
http://reply.papertrans.cn/48/4715/471417/471417_23.png
成绩上升
发表于 2025-3-25 17:48:41
Synthesis of the Optimal Structure of the Device for Control and Regulating the Working Gaps of thele. The mechanism for adjusting the working gap of such a system is equipped with a modern contactless sensor of the working gap width and an electronic unit and other modern blocks. It has been established that the disadvantages of this device are: the lack of the ability to control and regulate ad
防御
发表于 2025-3-25 21:09:32
Obtaining Liquid Hydrocarbons by Processing of Natural and Associated Petroleum Gas in a Flow Reacttor with a nonequilibrium electric discharge. The essence of this method is that in this reactor, a flow of natural gas of atmospheric pressure is exposed to a pulsed volume discharge. This discharge is initiated by a pulsed electric beam.
否认
发表于 2025-3-26 03:41:14
Research of Technological Modes of Production of Small Diameter Rods from Niobium, alloys with high values of strength and plastic characteristics in both deformed and annealed states, compared with the mechanical characteristics of niobium. The microstructure of niobium rods has been studied. It can be seen that rods made of niobium and its alloy with a diameter of 20–40 mm have
热心
发表于 2025-3-26 07:03:05
Geometrical Model for Tool Wear Assessment in the Processing of Reinforced Composite,ata on turning, drilling and milling of polymer composites, published in the open press, a theoretical model for assessing tool wear was proposed. This model is based on an analytical description in tool geometry change over time. One of the most effective, simple and accurate methods for determinin
inscribe
发表于 2025-3-26 11:47:16
Assessment of Methods for Fan Blades Arrangement for Static Balancing of the Fan of a Turbofan Engi disk imbalance within limits when repairing or replacing fan blades a fan blades rearrangement procedure must be applied. In this work various methods of fan blades (re)arrangement are suggested and evaluated by applying them on large number of randomly generated sets of fan blades for a typical co
STALE
发表于 2025-3-26 15:10:17
Analysis and Synthesis of Mobile Portable Machine Tools Layouts,ine‘s demand to perform repair work or modernize the structures of large-sized equipment, the dismantling of which is impossible or not economically feasible. The increase in demand for such equipment makes it necessary to reduce the design and production time for this type of machine tool, with unc
奇怪
发表于 2025-3-26 17:03:41
Creation of a Superhydrophilic Surface with Anti-icing Properties for X18H10T Stainless Steel Usingce, on which micro-/nano-rough structures are created to change the contact angle between the textured surface and a liquid drop..In this work, several models of linear microstructures were textured with a nanosecond laser on the 12X18H10T stainless steel surface, which is of interest to the aviatio