resuscitation
发表于 2025-3-30 11:36:59
Mismatch in Anthropometric Parameters of Malaysian Manufacturing Workersmanufacturing. In contrast with Computer Aided Three-dimensional Interactive Application (CATIA), DELMIA ergonomics feature is built with Human Task Simulation which can simulate the design workspace virtually. However, population available for the human manikin population are excluding Malaysian po
心痛
发表于 2025-3-30 15:36:11
Development Tools of an Adaptive Controllerrietary system. In traditional CNC system, most predefined numerical control (NC) commands programmed at early stage were often found to be unsuitable or sometimes unusable especially when the machining process was interrupted by unscheduled event. This will result in additional effort spent for adv
屈尊
发表于 2025-3-30 18:22:36
http://reply.papertrans.cn/47/4699/469803/469803_53.png
Phagocytes
发表于 2025-3-30 23:08:41
Suppression on Effect of Cutting Forces Towards Tracking Performance in Milling Cutting Process Usinring the milling operation. The undesired frequency harmonics of the cutting force contributes negatively to the positioning accuracy; thus an effective compensation of these harmonics is desired. This paper presents results related to suppression of cutting forces in milling process for minimal imp
FLOUR
发表于 2025-3-31 01:25:02
Effect of Filler Loading on Tracking and Erosion of Silicone Rubber Based Composites Under DC Voltagns, benefited from their excellent electrical performance. However, SiR also suffered from many drawbacks since electrical properties are becoming the major factors to the failure of insulation. Thus, by varying filler loading also is considered as an alternative way to improve the properties of SiR
休闲
发表于 2025-3-31 07:16:31
Design and Implementation of Cascade NP/PI Controller for Feed Table Ball Screw Driven Milling Machiontrol structure resulting in cascade NP/PI controller. The controller design process involved three main steps, namely; (i) design of PI controller for the speed loop, (ii) design of P controller for the position loop, and (iii) design of the nonlinear function. The speed and position controllers w
Laconic
发表于 2025-3-31 09:44:32
http://reply.papertrans.cn/47/4699/469803/469803_57.png
大厅
发表于 2025-3-31 13:39:34
Optimization of Multi-holes Drilling Path Using Particle Swarm Optimizationble to reduce the time taken in machining process. This paper is focus on the modeling and optimization of multi-holes drilling path. The problem is modeled as traveling salesman problem (TSP) and optimized using Particle Swarm Optimization (PSO). To test the PSO performance, 15 test problems were c
古代
发表于 2025-3-31 17:57:24
http://reply.papertrans.cn/47/4699/469803/469803_59.png
杀虫剂
发表于 2025-4-1 00:40:26
http://reply.papertrans.cn/47/4699/469803/469803_60.png