Calculus
发表于 2025-3-27 00:53:46
B. Nečasová,P. Liška,J. Šlanhof to retain the hierarchical information of different scales, and the attention mechanism is introduced to further explore information in different sizes and channels to prevent the abuse of advanced features effectively. We conducted experiments on the COCO-20i dataset, and our model can obtain good
名义上
发表于 2025-3-27 03:22:55
Jochen Taiber,Martin Kahlmeyer,Andreas Winkel,Eva-Maria Stübling,Fatima Taleb,Mikhail Mikerov,Stefanand proposes a general-purpose end-to-end deep reinforcement learning framework based on dual agents to track and attack targets accurately in different scenarios. Aiming at the problem that it is difficult for mobile robots to accurately track targets and evade obstacles, this paper uses partial ze
项目
发表于 2025-3-27 08:53:22
Some Industrial Examples of Accelerated Curing Using Curie Particles,dhesive increased with increasing both the induction frequency and the particle content. However, the lap shear strength of joints with Araldite 2011 was reduced by 17% when increasing the particle content to 30%. No impact on the strength was observed in the case of the Jowat 690 at 16.7 and 30% pa
磨碎
发表于 2025-3-27 11:11:50
http://reply.papertrans.cn/47/4640/463935/463935_34.png
Contort
发表于 2025-3-27 17:18:17
Development of an Elasto-plastic Meshless Technique to Analyse Bonded Structures,re simulated utilising the FEM and NNRPIM methodologies, and . were calculated from those simulations. Finally, the results were compared against the first and second benchmarks. The meshless method proved to be a good alternative to the FEM, providing similar strength prediction. Moreover, the stre
连系
发表于 2025-3-27 20:25:44
Techniques for the Mechanical Characterization and Numerical Modelling of Bonded Automotive Structungineering (INEGI) has focused extensively on processes for high strain rate characterization of the mechanical behaviour of modern crash testing adhesives for the automotive industry. Special testing procedures and experimental equipment have been developed for the determination of strain rate depe
EXALT
发表于 2025-3-27 23:33:14
Analysis of Temperature Effect on Deformation Behaviour and Bond Strength of Adhesive Joints with Smer adhesive systems were tested, four in total, in combination with different representatives of the substrate. Joint design similar to butt joint was used, therefore each test sample was composed of two components: (1) EN AW-6060 (AlMgSi) T66 aluminium alloy disc; and (2) the tested substrate: (a)
BACLE
发表于 2025-3-28 02:34:46
http://reply.papertrans.cn/47/4640/463935/463935_38.png