Inkling
发表于 2025-3-30 09:13:04
https://doi.org/10.1007/978-3-642-56171-9terms of the local energy dissipation rate e, then is found to have a similar form to that in other ‘shear-free’ boundary layers such as in thermal convection boundary layers. Since the impinging turbulence controls the viscous surface layer, it also controls the diffusion layer very close to the su
nascent
发表于 2025-3-30 15:06:03
http://reply.papertrans.cn/39/3808/380758/380758_52.png
补角
发表于 2025-3-30 20:31:35
Arbeitsleistung und Arbeitsgütethe surface fluctuated rapidly from 0.3 to 16 cm sec.. The mean speeds were ca. 5 cm sec. and the turbulent intensities (ratio of rms speed to mean speed) were greater than 0.4. There was a graded shift from high frequency, high amplitude fluctuations at the surface to lower frequency, smaller ampli
外向者
发表于 2025-3-30 23:41:20
Book 1984ales. As a consequence, scientists and engineers from diverse disciplines and problem areas, have approached the problem, often with greatly differing analytical and experimental techniques and methodologies.
Daily-Value
发表于 2025-3-31 04:03:32
http://reply.papertrans.cn/39/3808/380758/380758_55.png
结果
发表于 2025-3-31 07:51:22
Physical-Chemical Phenomena and Molecular Propertiescussed. The various exchange mechanisms of diffusion (volatilization or absorption), deposition in association with particles both dry and wet, dissolution in rainfall, spray transfer and bubble transfer are reviewed briefly. It is shown that the physical chemical properties of the exchanging chemic
anchor
发表于 2025-3-31 10:48:26
http://reply.papertrans.cn/39/3808/380758/380758_57.png
红润
发表于 2025-3-31 14:02:24
http://reply.papertrans.cn/39/3808/380758/380758_58.png
Diluge
发表于 2025-3-31 19:02:58
The Ratio of Gas-Phase to Liquid-Phase Mass Transfer Coefficients in Gas-Liquid Contacting Processesss transfer rate constants to the two-resistance model with appropriate corrections for molecular diffusivities. We show that the ratio of mass transfer coefficients (k./k.) is significantly smaller than the suggested value of k./k. = 150 customarily used to model surface aeration, bubble aeration,