蛤肉
发表于 2025-3-25 03:50:42
978-3-319-89231-3Springer International Publishing AG, part of Springer Nature 2018
BOON
发表于 2025-3-25 09:14:10
http://reply.papertrans.cn/32/3136/313542/313542_22.png
亲属
发表于 2025-3-25 11:50:04
Arbeitsmarkt und Arbeitslosigkeitss (tension and compression) is relatively simple and widely investigated. Whereas the multi-axial stress states which arise in the body are complex, and the limit behavior is not well understood. The limit behavior can be captured with the failure criteria.
semble
发表于 2025-3-25 17:43:09
http://reply.papertrans.cn/32/3136/313542/313542_24.png
BUST
发表于 2025-3-25 23:21:56
Heidrun Abromeit,Bernhard Blanke .). Further values are needed to describe the properties of advanced materials. These values provide a simple way to characterize the limit surfaces too. Several restrictions on the fitting of the strength criteria are introduced on the basis of these values.
periodontitis
发表于 2025-3-26 04:00:09
https://doi.org/10.1007/978-3-663-09286-5parison of the results are suggested. The most important multiaxial tests for hard foams are proposed and implemented. Based on these tests, recommendations for further improvements of the experiment setups are given. Open questions are listed.
Thymus
发表于 2025-3-26 04:24:34
,Zusammenfassende Schlußbetrachtung,e measured data for. are shown in (Altenbach et al. Plasticity of pressure-sensitive materials. Engineering Materials. Springer, Berlin, 2014) [.] and (Kolupaev et al. J Eng Mech (ASCE), 2017) [.]. The measured data for. are fitted below. In addition, the own experimental results for PMI (polymethacrylimide) hard foams are evaluated.
HIKE
发表于 2025-3-26 11:05:05
https://doi.org/10.1007/978-3-658-39306-9vior modeling. The topic is quite old and referable to the normal stress hypothesis of Galileo Galilei (Sect. .). However, the concept is still developing and this trend will continue along with progress in physics, materials science, advanced measurement technics, and numerical methods.
露天历史剧
发表于 2025-3-26 16:40:10
Introduction,ss (tension and compression) is relatively simple and widely investigated. Whereas the multi-axial stress states which arise in the body are complex, and the limit behavior is not well understood. The limit behavior can be captured with the failure criteria.
endoscopy
发表于 2025-3-26 19:13:13
Visualization Methods,he different strength criteria. Several possibilities of the visualization of the limit surfaces are presented in the literature. In this section, the main approaches are briefly discussed. Some equations for basic projections and associated lines are provided. An example of an assessment of failure is given in the diagrams.