圆锥
发表于 2025-3-23 11:30:18
http://reply.papertrans.cn/31/3065/306484/306484_11.png
FOR
发表于 2025-3-23 14:40:55
http://reply.papertrans.cn/31/3065/306484/306484_12.png
assail
发表于 2025-3-23 18:39:59
Electronic Tubes,e devices, leaving the higher power stages of amplification in transmitters and similar equipment as the only places where vacuum tubes are used in the electronics industry excluding electro-optical devices in both TV cameras and receivers.
FAWN
发表于 2025-3-24 00:39:31
Conventional Bridge Measurements,ame as the volt drop along the bottom arm at the point D if the ratio of Rl to R2 is the same as the ratio of R3 to R4. That is R1/R2 = R3/R4. It follows therefore that if a galvanometer is connected between C and D it will indicate zero current if these conditions are satisfied. That is the bridge is in balance when R1/R2 = R3/R4.
漂亮才会豪华
发表于 2025-3-24 06:13:42
http://reply.papertrans.cn/31/3065/306484/306484_15.png
宇宙你
发表于 2025-3-24 08:46:35
Beschaffungs- und Einkaufsmanagement,ut stage saturates when the device operates. ECL is a form of Current Mode Logic which is nonsaturating and so achieves a faster switching speed. MOS transistors can be used with certain advantages in integrated circuits and these form a separate category.
相同
发表于 2025-3-24 14:13:42
http://reply.papertrans.cn/31/3065/306484/306484_17.png
Extemporize
发表于 2025-3-24 17:18:20
http://reply.papertrans.cn/31/3065/306484/306484_18.png
Incumbent
发表于 2025-3-24 22:58:48
Integrierte Materialwirtschaft und Logistike devices, leaving the higher power stages of amplification in transmitters and similar equipment as the only places where vacuum tubes are used in the electronics industry excluding electro-optical devices in both TV cameras and receivers.
foliage
发表于 2025-3-25 00:34:40
https://doi.org/10.1007/978-3-662-07946-1ame as the volt drop along the bottom arm at the point D if the ratio of Rl to R2 is the same as the ratio of R3 to R4. That is R1/R2 = R3/R4. It follows therefore that if a galvanometer is connected between C and D it will indicate zero current if these conditions are satisfied. That is the bridge is in balance when R1/R2 = R3/R4.