有恶意
发表于 2025-3-23 13:23:59
http://reply.papertrans.cn/29/2838/283779/283779_11.png
promote
发表于 2025-3-23 15:17:49
http://reply.papertrans.cn/29/2838/283779/283779_12.png
ingestion
发表于 2025-3-23 21:30:13
http://reply.papertrans.cn/29/2838/283779/283779_13.png
束以马具
发表于 2025-3-23 23:27:10
http://reply.papertrans.cn/29/2838/283779/283779_14.png
仲裁者
发表于 2025-3-24 04:37:02
http://reply.papertrans.cn/29/2838/283779/283779_15.png
Costume
发表于 2025-3-24 07:20:39
Quantification of Bias Errors Influence in Frequency Based Substructuring Using Sensitivity Analysiout the whole frequency range..This paper proposes a novel methodology to characterize bias errors in FBS based on the small deviations in impact excitation from typical experimental measurements. The deviations are utilized to reconstruct a range of bias-affected FRFs. These are then used in the gl
Maximize
发表于 2025-3-24 14:27:22
Identification of Bolted Joint Properties Through Substructure Decoupling,n already used in an iterative coupling–decoupling procedure to identify the linear dynamic behaviour of a joint, with a Virtual Point description of the interface. In this work, a similar identification procedure is applied to the Brake Reus Beam benchmark to identify the linear dynamic behaviour o
Affluence
发表于 2025-3-24 15:59:36
http://reply.papertrans.cn/29/2838/283779/283779_18.png
Chagrin
发表于 2025-3-24 19:33:47
http://reply.papertrans.cn/29/2838/283779/283779_19.png
Gleason-score
发表于 2025-3-25 02:02:05
Feasibility of Configuration-Dependent Substructure Decoupling,ements on the connecting DoFs; if, for the residual system, it is necessary to consider a different set of FRF measurements for each configuration; if it is possible to take advantage of the redundancy of information provided by considering multiple configurations, i.e. multiple internal constraints