性行为放纵者
发表于 2025-3-26 21:56:56
Introduction,t and bulk materials. Where insufficient thermal property contrast exists defects have a limited effect on heat propagation through a component and therefore are not detected using PT or PPT. A means of producing realistic kissing defects in bonded joints is established. The addition of a small load
chassis
发表于 2025-3-27 04:06:59
Preliminary Results,n testing bonded joint configurations. In all samples experimentally simulated defects were spaced sufficiently so that they could be studied individually, without interference from surrounding defects.
QUAIL
发表于 2025-3-27 07:05:05
Book 2016mponent and therefore are not detected using PT or PPT, this thesis discusses the addition of a small load to bonds containing kissing defects which was found to open the defects sufficiently to enable their detection. .A low cost infrared detector, Flir Tau320, is compared to the research based pho
Debrief
发表于 2025-3-27 11:30:06
http://reply.papertrans.cn/27/2700/269971/269971_34.png
彩色的蜡笔
发表于 2025-3-27 14:00:58
2190-5053of a small load to bonds containing kissing defects which was found to open the defects sufficiently to enable their detection. .A low cost infrared detector, Flir Tau320, is compared to the research based pho978-3-319-37377-5978-3-319-22982-9Series ISSN 2190-5053 Series E-ISSN 2190-5061
evince
发表于 2025-3-27 20:23:24
Development of Infrared Techniques for Practical Defect Identification in Bonded Joints978-3-319-22982-9Series ISSN 2190-5053 Series E-ISSN 2190-5061
设想
发表于 2025-3-27 23:52:25
http://reply.papertrans.cn/27/2700/269971/269971_37.png
芦笋
发表于 2025-3-28 04:06:59
Springer Theseshttp://image.papertrans.cn/d/image/269971.jpg
转换
发表于 2025-3-28 07:48:45
Grundlagen Export und Internationalisierungork on this matter has focused on the development of advanced ultrasonic techniques. The current thesis focuses on the use of thermography, specifically pulsed and pulse phase thermography (PT and PPT), for the identification of kissing defects. Initially the thesis focuses on the application of PT
欢乐中国
发表于 2025-3-28 10:50:38
Logistik, Transport und Lieferbedingungenas the potential to affect the strength of that bond. Industry requires a method of not only identifying such defects but also the setting of threshold criteria, to define acceptable/unacceptable defects. The threshold criteria are dependent on where the joint is to be deployed and tailored its appl