GEON
发表于 2025-3-25 03:59:56
http://reply.papertrans.cn/27/2686/268585/268585_21.png
Pelago
发表于 2025-3-25 09:56:06
http://reply.papertrans.cn/27/2686/268585/268585_22.png
verdict
发表于 2025-3-25 14:01:04
Brigitte Kerchner,Silke Schneidern. Then the evaluation of the cutting operation of the upper axle surface and finally the simulation of assembling the wheel on the axle with a static model, to better estimate the stress relaxation and redistribution.
表示问
发表于 2025-3-25 19:20:44
http://reply.papertrans.cn/27/2686/268585/268585_24.png
idiopathic
发表于 2025-3-25 23:12:04
http://reply.papertrans.cn/27/2686/268585/268585_25.png
Eosinophils
发表于 2025-3-26 01:45:22
http://reply.papertrans.cn/27/2686/268585/268585_26.png
conservative
发表于 2025-3-26 08:14:40
Optimisation of Machining Parameters in Hard Turning by Desirability Function Analysis Using Responsace roughness. However, a higher cutting speed improves the surface finish. In addition, a good agreement between the predicted and measured surface roughness was observed. Therefore, the developed model can be effectively used to predict the surface roughness on the machining of AISI 4140 steel wit
星球的光亮度
发表于 2025-3-26 11:38:38
Numerical Chain of Forging Railway Axle and Wheel Press Fitting Operationn. Then the evaluation of the cutting operation of the upper axle surface and finally the simulation of assembling the wheel on the axle with a static model, to better estimate the stress relaxation and redistribution.
puzzle
发表于 2025-3-26 12:56:17
http://reply.papertrans.cn/27/2686/268585/268585_29.png
北极熊
发表于 2025-3-26 19:32:39
http://reply.papertrans.cn/27/2686/268585/268585_30.png