FLIP 发表于 2025-3-30 09:38:12

http://reply.papertrans.cn/25/2420/241978/241978_51.png

Gesture 发表于 2025-3-30 16:18:35

Endurance Limit,after fatigue tests are illustrated. The effect of the mean stress on the cyclic fatigue was measured for sintered zirconia. Unlike in ferrous alloys in other materials a continuously decreasing S–N curve is exhibited.

缓解 发表于 2025-3-30 18:29:35

Stress Cycles,ncept. Alternating stresses in the elastic region are associated with high cycle fatigue. Stress life and strain life methods are present for fatigue life prediction. Very high cycle fatigue tests are also presented in this section.

Flirtatious 发表于 2025-3-30 22:20:35

The Effect of Environment, environment. Some of these environments were applied in the experimental investigations of alumina, yttria stabilized zirconia, SiC and Si.N.. In particular comparison of the mechanical properties in water and air should be emphasized, although tests were investigated in vacuum also.

机密 发表于 2025-3-31 03:21:57

2522-560X ects on fatigue.This book presents the fatigue properties of structural materials used for the production of ceramics. It explains the cyclic deformation and how failures occur by fatigue. Dislocations related to fatigue are examined. The way that fatigue induces structural changes in material under

包裹 发表于 2025-3-31 08:10:54

Marilyn P. Safir,Helene S. Wallach total fatigue life. Cycles to failure in alumina SiC composite and yttria stabilized zirconia were applied for the determination of the fatigue limit. The SiC is reinforced by SiC fibers to improve high temperature strength. The moisture in air affect the cyclic behavior of SiC deteriorating its properties.

macabre 发表于 2025-3-31 10:19:49

https://doi.org/10.1007/978-3-319-00293-4e changes. Thermal fatigue cannot be prevented, but there are ways to prevent failure due to thermal fatigue. Avoiding temperature fluctuations in particular during shutdown and start-up of a component can help to prevent thermal fatigue.

Choreography 发表于 2025-3-31 16:06:09

http://reply.papertrans.cn/25/2420/241978/241978_58.png

愤怒事实 发表于 2025-3-31 18:55:30

Katharina Meyerbröker,Paul M. G. Emmelkamp, and the pinning by loops is considered. S–N fatigue data in some of the materials indicated above is discussed. Sand blasting improves surface properties of some of the listed substances. Fractured surface of B.C showed twin formation during deformation by SEM and TEM.

faultfinder 发表于 2025-4-1 01:00:29

http://reply.papertrans.cn/25/2420/241978/241978_60.png
页: 1 2 3 4 5 [6]
查看完整版本: Titlebook: Cyclic Deformation in Oxides, Carbides and Nitrides; Alumina, Magnesia, Y Joshua Pelleg Book 2022 The Editor(s) (if applicable) and The Aut