palliative-care
发表于 2025-3-28 14:42:19
Effect of Water Temperature on Hygrothermal Aging of GFRP Panel,ous E-glass fibre mat reinforced polyester which have different fillers. The specimens are immersed in hot water at 60°, 80° and 95° C and then weight changes and bending properties are measured. The water temperature affects the weight changes but it never affects the changes in bending properties
易受刺激
发表于 2025-3-28 22:01:56
http://reply.papertrans.cn/24/2319/231831/231831_42.png
Compatriot
发表于 2025-3-28 23:31:24
http://reply.papertrans.cn/24/2319/231831/231831_43.png
金丝雀
发表于 2025-3-29 05:43:26
Application of Numerical Analysis to One-Piece SMC Panels, shots. In an earlier work the authors used finite element analysis to analyze the in-mold flow behavior of sheet molding compound (SMC) during the compression molding process. In the present work a new analytical procedure has been devised for making a detailed analysis of the flow behavior of SMC
FACT
发表于 2025-3-29 10:23:45
http://reply.papertrans.cn/24/2319/231831/231831_45.png
歪曲道理
发表于 2025-3-29 11:45:50
Fabrication and Structural Performance of CFRP Wind Cups of the Three-Cup Anemometer,up are mainly aerodynamic force and centrifugal force. The stresses on the cup shell are caused by the distribution of air pressure which is low, but sufficient strength and stiffness are needed in the joint between the shell and the arm of the cup..In this work, unidirectional carbon fiber facing p
恩惠
发表于 2025-3-29 18:09:44
https://doi.org/10.1007/978-3-540-72978-5ly thick to thin situations using a discrete Kirchhoff technique. The second aspect pertains to the prediction of the onset of local delamination in the post buckling range and accurate determination of transverse shear stresses in the laminated structures. The accuracy and effectiveness of the fini
Cytokines
发表于 2025-3-29 21:33:18
Analysieren von Mehrfachantworten,ndently, due to their different material characteristics. With this assumption, each layer can deform locally, this being a more accurate model for high-stress gradient areas..In each layer, transverse shear deformation is considered by the imposition of Mindlin-type kinematic relations. In the disp
agglomerate
发表于 2025-3-30 00:20:30
Arbeiten im Ausgabe- und Syntaxfenster,relationship between changes in various molding factors and the resulting severity of sink marks can be analyzed quantitatively. The results of the present work are now being used to establish a molding concept for a one-piece outer panel.
Corroborate
发表于 2025-3-30 06:46:40
http://reply.papertrans.cn/24/2319/231831/231831_50.png