附录
发表于 2025-3-28 14:44:16
Defect Analysis and Prevention,d that multiple crystalline phases coexisted in the glass-ceramics, and the main crystalline phases were diopside and anorthite. SEM observation indicated that there was a plate-columnar composite structure in the ceramics. Reaction mechanisms were discussed.
阴谋
发表于 2025-3-28 21:58:10
Process Control and Optimization,onditions of raw materials with 1 wt% PAM addition, humics and CMC with a mass ratio of 3:1 in binder, and the raw materials mixed in an interval order. Humics has the potential to be used as a novel, eco-friendly and high-efficient binder for lithium-ion battery.
过滤
发表于 2025-3-29 00:23:23
Defects, Hypotheses, And tests,verall compressive strengths increased with strain rate. Although the Knoop hardness values were much lower in the 85% alumina due to the porosity, the compressive strength at both quasi-static and dynamic strain rates were not significantly lower than those of the 99.5% composition.
可用
发表于 2025-3-29 05:39:21
http://reply.papertrans.cn/23/2240/223996/223996_44.png
刚开始
发表于 2025-3-29 07:53:13
On FIB Milling ParametersHowever, for most of the laboratories that is limited by conventional Ga ion FIB, the milling speed is limited by the relatively small beam current. In this paper, FIB milling rate are studied against milling parameters that include beam dwell time and pixel overlap. By optimizing the milling parameters, milling rate can increase significantly.
SOBER
发表于 2025-3-29 12:16:57
http://reply.papertrans.cn/23/2240/223996/223996_46.png
keloid
发表于 2025-3-29 18:23:06
http://reply.papertrans.cn/23/2240/223996/223996_47.png
Servile
发表于 2025-3-29 20:46:22
Correlation of Microstructure to Mechanical Properties in Two Grades of Aluminaverall compressive strengths increased with strain rate. Although the Knoop hardness values were much lower in the 85% alumina due to the porosity, the compressive strength at both quasi-static and dynamic strain rates were not significantly lower than those of the 99.5% composition.
开玩笑
发表于 2025-3-29 23:53:01
Propagation of Power Ultrasound in Calcium Ferrite Melt ultrasonic power promotes the acoustic pressure amplitude in the CF melt, while increasing frequency decrease the acoustic pressure amplitude. The acoustic pressure amplitude with the frequency closer to the resonant frequency may get the best cavitation effect because its average acoustic pressure is greater than those of others.
grudging
发表于 2025-3-30 06:08:12
http://reply.papertrans.cn/23/2240/223996/223996_50.png