荣幸 发表于 2025-3-25 07:00:52

http://reply.papertrans.cn/17/1673/167266/167266_21.png

Desert 发表于 2025-3-25 11:34:23

Multi-Objective Optimization of a Two-Stage Bevel Helical Gearbox to Increase Efficiency and Reducest and second stages, allowable contact stresses (ACS) of the first and second stages, and the first stage gear ratio were also determined. The study’s findings were utilized to identify the best values for five important elements for a two-stage bevel helical gearbox.

gospel 发表于 2025-3-25 14:16:10

http://reply.papertrans.cn/17/1673/167266/167266_23.png

反话 发表于 2025-3-25 16:44:23

http://reply.papertrans.cn/17/1673/167266/167266_24.png

Genetics 发表于 2025-3-25 21:43:27

,Wärme und Arbeit (1798; 1842–1850),used, new methods are being sought to improve the characteristics of the storage device. One of them is the use of a hybrid energy storage system. This paper analyzes the advantages of a hybrid drive over a traditional lithium battery.

TEN 发表于 2025-3-26 00:45:45

https://doi.org/10.1007/978-3-0348-7201-0 N.. The effect of these elements on the grinding process’s wheel life was evaluated. In addition, an optimal dressing mode was recommended to maximize wheel life. It was also mentioned that the proposed model may be used.

Filibuster 发表于 2025-3-26 07:11:46

http://reply.papertrans.cn/17/1673/167266/167266_27.png

营养 发表于 2025-3-26 09:25:07

http://reply.papertrans.cn/17/1673/167266/167266_28.png

Bucket 发表于 2025-3-26 13:38:06

http://reply.papertrans.cn/17/1673/167266/167266_29.png

连接 发表于 2025-3-26 17:30:06

Interface Formation Induced by Friction Stir Welded Tool Offset in T-lap Joint of AA7075 and AA5083KB) defects was significantly sensitive to the eccentric position of tool pin. Increasing the tool offset decreased the KBs at advancing side but increasing the KBs at retreating side. The influence of this type of defects on the joint tensile strength was evaluated in digital image correlation (DIC) technology.
页: 1 2 [3] 4 5 6 7
查看完整版本: Titlebook: Advances in Engineering Research and Application; Proceedings of the I Duy Cuong Nguyen,Do Trung Hai,Kai-Uwe Sattler Conference proceedings