CANDY
发表于 2025-3-23 11:06:11
http://reply.papertrans.cn/16/1564/156393/156393_11.png
nutrients
发表于 2025-3-23 17:21:06
Practical Machining Processes,ting edge geometry and number of edges as a classification scheme, this progression can be thought of as going from a case that is similar to the orthogonal and oblique models of Chapter 3, to multiple cutting edges that make intermittent cuts, to the complicated multiple edges of the drill.
走调
发表于 2025-3-23 20:26:24
Introduction,ore difficult to find, e.g., machinists, process planners, and tool designers. As a result, engineers will need to provide this knowledge. This book provides the technological knowledge about material removal needed for setting up, operating or understanding the reasons behind experience based “rule
Ancestor
发表于 2025-3-24 01:43:23
0941-5122interpreting the experience of planning, operating and improving a metal removal process based on rule of thumb approaches.978-1-4612-8759-9978-1-4612-4408-0Series ISSN 0941-5122 Series E-ISSN 2192-063X
辩论的终结
发表于 2025-3-24 06:15:54
http://reply.papertrans.cn/16/1564/156393/156393_15.png
尖牙
发表于 2025-3-24 09:11:52
Textbook 1992nowledge, often times at an elementary level, for handling the technological aspects of setting up and operating a metal removal process and interpreting the experience of planning, operating and improving a metal removal process based on rule of thumb approaches.
过份艳丽
发表于 2025-3-24 12:51:57
Introduction, the primary manufacturing process or an important part of preparing the tooling for other processes like forming or molding. In recent years industry and educational institutions have concentrated on the material removal system, perhaps at the expense of the process. This book concentrates on mater
Inscrutable
发表于 2025-3-24 16:42:50
Metrology, Quality Control and Data Analysis,es the shape of a part in other chapters. Tolerances on dimensions and surface finish are used for comparing different processes, and when the tolerances or surface finish specified are small, this usually leads a process planner to choose machining or grinding processes. Metrology, the science of m
anthropologist
发表于 2025-3-24 22:59:12
http://reply.papertrans.cn/16/1564/156393/156393_19.png
exercise
发表于 2025-3-25 01:49:11
Edge Materials, Wear and Fluids for Cutting and Grinding,lations in Chapter 3 treated the interfaces at the rake face of the cutting edge or wheel contact region in grinding as if everything was known in a very precise and quantitative way. In reality this is not the case. This chapter covers cutting edge materials and fluids applied at the interface, whe