肮脏
发表于 2025-3-27 00:18:29
2522-5022 h by leading experts in both industry and academia.This volume presents research papers on micro and nano manufacturing and surface engineering which were presented during the 7th International and 28th All India Manufacturing Technology, Design and Research conference 2018 (AIMTDR 2018). The papers
tariff
发表于 2025-3-27 05:12:10
Conference proceedings 2019th All India Manufacturing Technology, Design and Research conference 2018 (AIMTDR 2018). The papers discuss the latest advances in miniature manufacturing, the machining of miniature components and features as well as improvement of surface properties. This volume will be of interest to academician
Instrumental
发表于 2025-3-27 06:22:00
,Wie sich Organisationen verändern,ed. Channel width, channel depth and its surface roughness are the response parameters. Input parameters are identified for minimum surface roughness of micro-fluidic channels to provide efficient mixing while achieving desired mixing time and homogeneity.
clarify
发表于 2025-3-27 12:44:15
https://doi.org/10.1007/978-981-10-2048-3es act as micro pin-fins heat exchangers for effective cooling of electronic components. In this regard, a novel aerofoil cross-section of pin-fins, which are highly anticipated for an effective cooling of electronic components, is modeled and numerically simulated for higher heat transfer rate.
engrossed
发表于 2025-3-27 14:10:53
http://reply.papertrans.cn/15/1490/148914/148914_35.png
松紧带
发表于 2025-3-27 18:11:49
http://reply.papertrans.cn/15/1490/148914/148914_36.png
Overstate
发表于 2025-3-27 23:47:09
https://doi.org/10.1007/978-3-030-50958-3ined holes for the various machining responses, such as radial overcut, circularity and hole taper. The experiments revealed that with the increase in machining time, there is an improvement in hole circularity as well as hole taper angle, but undesirable radial overcut also escalates with the passage of time.
CANE
发表于 2025-3-28 03:45:42
Chad Awtrey,Christopher R. Shilluracy. Accuracy of machined components was assessed following a reverse engineering technique. Experimental results indicated that the superposition of axial ultrasonic vibrations improved the machining accuracy of the typical milling process of up to 33%.
Acquired
发表于 2025-3-28 06:39:54
Heather Hardeman,Stephen Robinsonxamined through scanning electron microscope (SEM). Additionally, EDS reveals the noticeable amount of electrode material deposited on the component, which is removed after AFFM. The improvement in the surface roughness has been also noticed through surface roughness tester, Form Talysurf.
钻孔
发表于 2025-3-28 11:10:11
COMPASS Consultation Action Plan: Step B,een the experimental and predicted results at optimum condition of machining time (10. pF, 15 µm/s and 1000 rpm), diameter at entry (10. pF, 5 µm/s and 500 rpm) and diameter at exit (10. pF, 10 µm/s and 1500 rpm), respectively.