离开就切除
发表于 2025-3-28 15:15:38
http://reply.papertrans.cn/15/1488/148744/148744_41.png
勉强
发表于 2025-3-28 22:33:42
Co-Creation in Higher Educationf FSW joints. The tool rotational speed and weld speed were varied from 545 to 1070 rpm and 20 to 50 mm/min, respectively. In order to study the effect of individual process parameters on joint tensile strength, bottom-up approach was used. It is observed that at 765 rpm and 20 mm/min process condition, maximum tensile strength was obtained.
cleaver
发表于 2025-3-29 01:02:51
http://reply.papertrans.cn/15/1488/148744/148744_43.png
ADORE
发表于 2025-3-29 03:46:01
978-981-15-9119-8The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Singapor
入会
发表于 2025-3-29 11:08:37
http://reply.papertrans.cn/15/1488/148744/148744_45.png
保全
发表于 2025-3-29 14:57:19
https://doi.org/10.34156/978-3-7910-5064-5achieve desire surface qualities. In this paper, the effect of circular and point-to-point interpolation on the surface finish and form is investigated on a spherical disk with deep radius. Taguchi L. array is used to conduct the experiments on polymethylmethacrylate (PMMA). The machining parameters
眉毛
发表于 2025-3-29 18:06:00
https://doi.org/10.34156/978-3-7910-5064-5s on hard material. In this research work, through hole has been drilled on AISI 304 material using solid and tubular tool of copper material. The performance of electro-discharge drilling process has been measured in terms of material removal rate, tool wear rate and surface roughness. Further, the
Nonflammable
发表于 2025-3-29 20:43:44
http://reply.papertrans.cn/15/1488/148744/148744_48.png
到婚嫁年龄
发表于 2025-3-30 00:50:36
The Basic Assumptions of Co-creation,h a highly efficient and focused approach to manufacturing effectiveness. Study has been made on effect of wire electrode material and wire diameter on WEDM performance of aluminium metal matrix material Al+SiC has been reported. Plain brass and zinc coated brass wire having diameter 0.25 and 0.3 mm
陈旧
发表于 2025-3-30 07:59:48
The Eight Steps of the Co-creation Process,n some electrically assisted non-conventional machining methods find difficulty to develop features on such materials owing to their non-conducting nature. Microslots are developed on quartz glass slices through Wire electrochemical discharge machining process using zinc-coated brass wire with 0.1 m