错
发表于 2025-3-26 21:09:11
http://reply.papertrans.cn/15/1459/145809/145809_31.png
SLUMP
发表于 2025-3-27 01:36:26
Mechanical Characterisation of Graded Single Lap Joints Using Magnetised Cork Microparticlessons. The findings indicate that histograms of radar imaging exhibit varying characteristics across different scenes, necessitating the use of different models for fitting. The research findings play a crucial role in various radar applications, encompassing a broad spectrum from target identification to image enhancement.
狂乱
发表于 2025-3-27 09:00:22
http://reply.papertrans.cn/15/1459/145809/145809_33.png
recession
发表于 2025-3-27 10:49:06
Connected, Digitalized Welding Production—Secure, Ubiquitous Utilization of Data Across Process Laye Error (RMSE). The testing accuracy of Random Forest Regressor was found to be 0.9822175620286142, Particle Swarm Optimization 0.9809447466912986, K-Neighbors Regressor 0.9683118493918951 and Decision Tree Regressor 0.9675318135094464. It was observed that the testing accuracy of Random Forest Regressor was the best as compared to the rest others.
Mucosa
发表于 2025-3-27 13:50:08
http://reply.papertrans.cn/15/1459/145809/145809_35.png
极力证明
发表于 2025-3-27 19:34:12
Lecture Notes in Computer Scienceented that an increase in strength can be realized by additional local material bond of a clinched joint in the static case without causing a reduction in strength in the cyclic load case. Furthermore, it is shown that a local material bond at the undercut or outside a clinching joint has no increas
Ascendancy
发表于 2025-3-28 00:27:34
http://reply.papertrans.cn/15/1459/145809/145809_37.png
Cubicle
发表于 2025-3-28 05:38:48
Bridging the Inferential Gaps in Healthcarecantly higher resistance to loosening under a harmonic transverse load. Results show also that reducing thread fit clearance (i.e., thread fit class) and/or reducing the hole clearance would increase the resistance to vibration-induced loosening.
cruise
发表于 2025-3-28 06:26:34
Design of Algorithms for Big Data Analyticsrement for the selection of the alloy. Usually, the focus is on the process parameter settings. In this case, the specific admixture of alloy components based on the requirements for the respective application is identified as an integral process factor. Especially, reflectivity at a determined wave
寄生虫
发表于 2025-3-28 12:10:45
Ruchita Bansal,Siddharth Dawar,Vikram Goyalische Universität Darmstadt. The challenge in the additive manufacturing of structures with overhang is that the weld is not applied to a horizontal surface but sideways to the previous layer of weld. The molten pool then threatens to drop down before it hardens. Even without lateral dripping, clump