Brain-Waves
发表于 2025-3-25 06:22:33
Saeedeh Abbasi,Masoud Barati,Gino Limted, and the peel resistance was evaluated using a 90° peel load. It has been shown that 2C epoxy adhesives can be cured evenly between two nickel foils with the aid of induction heating. Strengths comparable to convective oven curing were achieved.
宽敞
发表于 2025-3-25 08:23:17
https://doi.org/10.1007/978-3-319-60204-2n time, but not linearly. Furthermore, optimal sonication time differs between resin and hardener with the same CNT weight ratio. Tensile tests reveal that 0.1 wt% CNTs provide the highest shear strength. Additionally, it was found that increasing overlap length reduced the average shear strength in joints containing CNTs.
exacerbate
发表于 2025-3-25 13:33:15
Martin Mihajlov,Borka Jerman-Blazicstry, technical lignin is produced in large quantities, either as kraft lignin or lignosulfonate, depending on the process. The largest part of the obtained technical lignin is however burned for energy recovery. Furthermore, lignin is also obtained as organosolvlignin in biorefineries, albeit still
远地点
发表于 2025-3-25 18:41:33
http://reply.papertrans.cn/11/1029/102817/102817_24.png
尖
发表于 2025-3-25 21:07:42
http://reply.papertrans.cn/11/1029/102817/102817_25.png
LATER
发表于 2025-3-26 03:21:19
Advances in Human Factors in Cybersecurity in the 1960s, but only in the last two decades has the interest in this type of adhesives increased due to new possible applications, such as medical plasters and assembly tapes. Products based on Si-PSA materials are used especially in systems exposed to very high and low temperatures due to their
Conclave
发表于 2025-3-26 06:02:00
http://reply.papertrans.cn/11/1029/102817/102817_27.png
subordinate
发表于 2025-3-26 09:34:28
https://doi.org/10.1007/978-3-319-60204-2nanotubes (CNTs), which exhibit notable potential based on existing studies. However, achieving uniform dispersion of CNTs within adhesives remains challenging. While ultrasonication is a common method, adjusting parameters for optimal dispersion is often overlooked. This study addresses this gap by
马赛克
发表于 2025-3-26 16:41:33
https://doi.org/10.1007/978-3-319-41950-3and for the optimization of productivity, enhancing automation, reduction in process time and increasing the quality of part joining, allowing to manufacture high performance protective enclosures for electrical circuits. In this context, the laser welding process has gained importance especially wh
吃掉
发表于 2025-3-26 17:06:27
Susan Stevens Adams,Francis P. Hannigand of unidirectional carbon fiber reinforced epoxy laminates were assessed using Double Cantilever Beam (DCB) and End-Notched Flexure (ENF) tests. These joints, bonded with an epoxy adhesive, were exposed to a saline environment for degradation periods of 1 and 12 weeks, as well as evaluated in their