青石板
发表于 2025-3-23 10:39:05
Azadeh Hassannejad Nazir,Hans Liljenströmn the joint strength. The results indicate the reduction of strength at the aged sample with the increased aging time. The crack initiates dominantly at the interfaces between the porous Cu/SAC305. In general, solder joint soldered with P25 of porous Cu joints have greater tensile strength (23 MPa)
spinal-stenosis
发表于 2025-3-23 15:29:32
https://doi.org/10.1007/978-981-10-0207-6ted. Very high welding speed (300 mm/min) resulted in very short heat cycle with no obvious amorphous phase and very small amount of intermetallic compound at the aluminum-to-steel interface. The formation process of the amorphous phase is schematically explained in this study.
brachial-plexus
发表于 2025-3-23 20:54:34
Xiaochuan Pan,Rubin Wang,Masamichi Sakagamite and frictional contact between joint members. The influence of different loading and unloading rates is emphasized on the sealing performance of flange joint using leakage pressure. The gasket deforms more when loaded at low rate. This phenomenon also affects the ability to withstand internal flu
形上升才刺激
发表于 2025-3-23 22:55:50
Advances in Cognitive Neurodynamics (VI)IG welding and machined again in order to perform tensile test. Tensile test was performed according to ASTM E8 standard in order to determine the strength of the welded pipe. Based on the values obtained from the tensile test such as Yield Strength and Ultimate Tensile Strength (UTS), the optimum b
考博
发表于 2025-3-24 05:25:38
Zaizhi Wen,Jianhua Zhang,Xiaochuan Panrial. In contrast, the increase of the transverse speed decrease the welding temperature. The results also demonstrate that the temperature profile during the welding is asymmetrically distributed in the welding cross section (temperature being higher on the advancing side). Experimental measurement
foliage
发表于 2025-3-24 07:18:31
2nd International Conference on Mechanical, Manufacturing and Process Plant Engineering978-981-10-4232-4Series ISSN 2195-4356 Series E-ISSN 2195-4364
recede
发表于 2025-3-24 12:32:15
Mokhtar AwangPresents selected papers from the 2nd ICMMPE conference which was hold from 23rd to 24th November, 2016 in Kuala Lumpur, Malaysia..Includes supplementary material:
Atheroma
发表于 2025-3-24 15:05:14
Lecture Notes in Mechanical Engineeringhttp://image.papertrans.cn/012/image/100617.jpg
obnoxious
发表于 2025-3-24 21:08:12
http://reply.papertrans.cn/11/1007/100617/100617_19.png
Admire
发表于 2025-3-24 23:42:33
http://reply.papertrans.cn/11/1007/100617/100617_20.png